TB 1-2840-248-20-2
NOTE: Words and acronyms such as "new," "unk" or "N/A" will not be used on this form due to automation
tasks to be done at the national level.
(c) Preparation Instructions (By Block Number and Title) For Completion of Copy 2 of a
DA Form 2410 For Gains to the Army Inventory (Figure 1). Copy 1 of DA Form 2410 is not used for gains,
discard it.
SECTION I--IDENTIFICATION COPY 2
Block 1. Nomenclature. Enter the item name.
Block 2. NSN. Enter the national stock number of the item.
Block 3. Part number. Enter the part number of the item.
Block 4. Serial number. Enter the serial number of the item. Do not enter more than one serial number in
this block.
Block 5. CAGE code. Enter the Contractor and Government Entity (CAGE) code for the item, (this code can
be found on the data plate for the part or in the -23P manual). If you cannot find this code, leave this block
blank.
Block 6. No of prev O/Hs. For Retirement Life Components/Modules (RC) and Condition
Components/Modules (CC), enter "RC" or "CC" in this block. See TB 1-1500-341-01 to determine whether the
item is an RC or CC item.
Block 7. Time since last inst (hrs). Enter "O".
Block 8. Time since new (Hrs). Enter the total number of operating hours to the nearest hour that the item
has been operated since it was new.
Block 9. Time since overhaul (Hrs). If the item has been overhauled before, enter the number of hours to
the nearest hour that the item has been operated since the last overhaul. If the item is a RC or CC item, enter
"RC" or "CC" in this block.
Block 10. Failure code. Enter the removal/achievement code "SC1" from Table 1-4 of DA Pamphlet 738-
751.
Block 11. WUC (Work Unit Code). Enter the work unit code which applies for the item. (See TB 1-1500-
341-01)
Block 12. Position code. Leave blank.
Block 13. Component cumulative count/hours. Enter the total cumulative counts for the item entered in
block 1. This entry is required for engines, history recorders, modules, components and subcomponents
entered on the front and reverse sides of a DA Form 2408-16-1. Operating hours only will be entered for
components and modules entered on the engine DA Form 2408-16-1 that are not required to have a separate
DA Form
2408-16-1.
SECTION III REPAIR/OVERHAUL/GAIN DATA.
Blocks 14 through 26. Do not make entries in these blocks.
6
Previous Page
