Pilot station re-assembly:

TB 1-1520-238-20-66

(33) Install the shear pins in each SPAD Assembly in the Pilots Station. Refer to tasks 11.23

for the collective SPAD; 11.155 for the Directional SPAD; 11 .56 for the Lateral SPAD; and 11.173 for the

Longitudinal SPAD.

(34) Perform a BUCS Self Test, I/A/W reference c. page P-1. Follow message prompts.

(35) Perform the DASE Interactive FD/LS Check (DASE2), I/A/W reference b., task 4-2, page

4-5. Follow the message prompts and/or any corrective action messages.

(36) If both tests pass, the inspection is complete, proceed to paragraphs 8.d. and 8.e. for re-

assembly either test fails, troubleshoot I/A/W reference e.

d. Pilot station re-assembly:

CAUTION

Ensure that no fasteners, tools or debris (FOD) are allowed to drop down

into any open access covers above the Gun Turret/Forward Fuel Cell.

Failure to do so may require removal of the Gun Turret/ Forward Fuel Cell

to retrieve foreign objects. (1 ) Remove the Pilots Foot Guard/Shield (7-

311180008), I/A/W task 2.189. NOTE

Ensure that the LVDT connector J230 is reconnected to plug P230 (Pilots

Station Collective Cover) or a "BUCS FAIL" will result, reference task 11.44.

(2) Install the Pilots Collective Stick Cover, I/A/W task 11.44.

(3) Install the SPAD Access Panel (7-311111110-25) underneath the Pilots L/H Scuff Plate

position.

(4) Install the Pilots left-hand (L/H) Scuff Plate (7-311180010-19), I/A/W 2.182.

(5) Install the Pilots Cyclic Stick Cover I/A/W task 11.46. Install the panel (7-311113683-31)

directly aft of the cyclic (task 11.188).

(6) Install the Pilots Seat (if removed) I/A/W task 2.161. Observe all equipment preconditions,

cautions and warnings.

(7) Install the Pilots Foot Guard/Shield (7-311180008), I/A/W task 2.189.

(8) Access the Aft Avionics Bay, ensure the DASE Computer connectors P688, P686 and

P682 are secure, close access door R295.

e. TM 1-1 520-238-23-T-7, Aviation Unit and Intermediate Troubleshooting Manual for army Model

AH-64 Helicopter.

NOTE

Ensure that the LVDT connector J234 is re-connected to plug P234 (CPG Collective Cover) or a "BUCS Fail"

will result, reference task 11.44.

(1) Install the CPG's Collective Stick Cover, task 11.44.

(2) Verify the connection of P118/J118 and secure access panel B60, L60 and B65L, I/A/W

task

(3) Install the 30mm Gun Barrel into the Gun Receiver, I/A/W reference d.

f. FINAL RE-ASSEMBLY MOC:

(1) Perform a BUCS Self Test, I/A/W reference c., page P-1. Follow message prompts.

(2) Perform the DASE Interactive FD/LS Check (Dase 02) I/A/W reference b., task 4-2, page

4-5. Follow the message prompts and/or any corrective action messages.