TB 1-2840-248-20-2
(f) Preparation Instructions For Completion of a DA Form 2410. Backside of Copy 2 (Figure
4). Used to list repair parts replaced during repair, overhaul or rebuild of the item in block 1. It will be
completed by the maintenance activity including depot level maintenance, organic or contractor support that
completes the maintenance. When repair parts with serial numbers are reported, parts will be listed
individually as a quantity of 1. All parts used except common, bulk issued hardware will be listed as follows:
a. Fail code. Enter the failure code that best describes the reason why the item was removed and
replaced. If an item is removed to achieve other maintenance actions the removal/achievement code that
applies will be entered in this block. (See Table 1-2, 1-3, or 1-4 in DA Pamphlet 738-751.)
b. Qty. Enter the total quantity for each part.
c. Act. Enter the maintenance action code; "A" replaced, "B" adjusted, "C" repaired (Nonserialized). (See
Table 1-10 in DA Pamphlet 738-751.)
d. Nomenclature. Enter the name of the part.
e. Part number. Enter the manufacturers part number.
f. Serial number. Enter the serial number for each part removed. If the part does not have a serial
number, leave blank.
g. Cumulative counts/hours last depot repair. For T700/701/701C series engines enter the total
cumulative counts in block g upon removal of repair parts, that required history recorder information, from
engines or modules. The counts and operating hours can be found on the DA Form 2408-16-1. Leave this
block blank if parts removed are from engines or components that do not require history recorder counts.
16
Previous Page
